Be the first to review this product
LED strip CCT control and dimming 12-24V, max. 192W for aluminium profile installations
Installs beautifully in our aluminum profiles. Can be used with both 12V and 24V strips. Maximum load for 12V strip is 96W and for 24V strip is 192W (8A). With this controller, you do not need a dimmable transformer.
Dimmer and CCT controller for profile-mounted, CCT colour-temperature adjustable LED strip. The perfect solution for kitchen cabinet LED strip and other applications where there is no separate wall switch for the light but the light is powered by a continuous current. In addition to kitchen task lighting, it can also be used for wardrobes and various night lights etc.
Fits beautifully into our aluminium profiles. Can be used with both 12V and 24V strips. Maximum load with 12V strip 96W and with 24V strip 192W (8A). With this regulator you do not need a dimmable driver.
Installation
Plug in between the strip and the driver (i.e. output 12-24V and input 12-24V).
- Make sure you use a DC driver and not a DC driver. When switching, the power should be off.
- Make sure the plus "+" and minus "-" are connected correctly to the driver. The plus and minus must not be cross-connected, but the plus must be connected to the plus and the minus to the minus. The information can also be found on the back of the component.
- Make sure that the warm and cold tones of the tape go to their correct positions on the component.
Using
- Detection range: ≤10cm.
- Light ON/OFF adjustment: move your hand over the sensor once, at a distance of 10cm. Wait for the result (1,5 sec.).
- To switch between CCT adjustment mode and dimming mode: move your hand over the sensor twice, at a distance of 10cm. Wait 1.5 seconds and the sensor will flash either orange (CCT mode) or blue (dimming mode). In other words, wait calmly for the flash.
- Hold your hand in front of the sensor (at a distance of 10cm) to adjust the colour temperature of the light (orange mode) or the brightness (blue mode).
- The sensor remembers the previous hue and brightness used and lights up with the same settings when it is switched on again.
Size
Dimensions: 10x55mm
Guarantee (year) | 3 years |
---|---|
Watt | 192.00 |
Dimensions | 10x55mm |
Approved | CE, RoHS |
Muuta | Solder the CCT control and dimmer swich between the CCT led strip and the driver. |
IP Class | IP20 |