Motion PIR sensor switch with light level sensor, for recessed installation, IP20

The microwave sensor turns on the lights when it detects movement within the sensing range and when the light level is at the desired level. For example, whenever motion is detected or whenever motion is detected and it is dim. The sensor's radar detects motion within a 3m or 6m radius (adjustable). Installation is recommended e.g. in an AP 7 mounting box, because the PIR sensor is mounted in a hole and the material thickness can be max. The sensor switches on the lights when it detects movement and switches off after the last detected movement. The time delay can be adjusted between 5sec. and 8min.

How to set the microsensor in operation:

• Set the desired light level at which the motion sensor turns on the lights. If you want the lights to turn on in daylight, set the sensitivity to 2000 lux (the lights will turn on in light below 2000 lux) and if you want the lights to turn on only in darkness, set the sensitivity to 10 lux.
• Set the detection distance to 3m or 6m.
• Set the time delay, i.e. the time the lights are on after the last detected movement.

Specifications of the microwave sensor:

• On after last detected movement 10 sec, 1 min, 3 min, 5 min, 8 min
• Installation height 2,2 m - 4 m from floor or 1,8 m - 2,5 m for wall mounting
• Detection radius 3m, 6m (adjustable)
• Detection range 120 В°/360 В°
• Dimming 10 lx / 2000 lx (adjustable)
• Ignition delay 0,6 - 1,5 m/s
• Maximum load 800W (incandescent), 200W (LED and energy saving lamps)
• Power consumption 0.5W (when operating)
• Mounting hole 12mm
• Max. thickness of material to be mounted 4,4mm
• Protection class IP20