1m LED RGB+W 4000K STRIP SOLO, 15W/m (75W/5m) 24V HIGH CRI95 IP65

High quality 15W 24V RGB + W 4000K led strip!

This led strip uses RGB circuit with the 4000K HIGH CRI around 95 with (White colour). The led strip is dimmable. As a tape, it uses 3M tape that is extra durable and attaches the strip firmly. Led strip 15W (3x4W RGB +1x3W CCT) /meter is outputting enought for indirect moodlighting!

Lighting

The strip is controlled with our VaLO RF or Zigbee series remotes (or HUE, Conbee2 USB ) and RGBW reveivers and drivers. With these you can adjust freely RGB and White. The product can be seen at our showroom in Vantaa Koivuhaka. You can use this strip also with all of our RGBW DALI2 drivers or your own 24V controllers. 

This strip is mostly used in indirect lighting and for creating different moods. Perfect for spas, bars and terraces, also we have noticed that kids love this led strip. RGB+4000K led strip has 560 RGB and 4000K led circuits on a meter!. This makes the light perfectly even. If installed in a way you cannot see the light source ie. indirect light. There are no visible dots to be seen if looked straight to the light (or if installed next to a shiny wall).

Installation

LED strip comes in a 5m roll that can be cut to measure in every 5cm. We recommend that you solder the wanted lengths together as we have noticed that the fast clips tend to loosen after few years and then the light starts flickering. There are 10 cm of mounting cable soldered to both ends of the strip. We will help you with any installation questions.

If you have more than 10m of RGB+4000K led strip, you need to feed the power from both ends to minimize the powerloss. All installations should be made on top of aluminium (ie. aluminium profile), that way the excess heat gets conducted away from led circuit and makes it last longer. Strip is 12mm wide, with thick copper base.

LED strip works well with solar power and in boats and cars, as it is 24VDC you might not even need a driver, just controller!

Remember to order a 24V driver and controller. For the whole 5 meters you need a minimum of 75W driver.

Dimming

5 meter LedStore's RGB+4000K led strip requires at least 75W Zigbee 24V Driver and HUB/remote. This is a perfect solution also in places where you have power for the strip but no wall switch ready. With this system, you just hook the wireless receiver between led strip and driver and have the remote were ever you like.

Create a light of your own

Why would you use led strip only in traditional way (cabinets, indirect light etc.) when you can make a light of almost anything. Old cart wheel, zink bucket or even a wooden boat turns in to a light when you put led strip inside it! Get creative!

Light colour temperature

RGB (red, green and blue) and Neutrall white colour (4000K).