VaLO RF Wireless control

For wireless control you need 2 parts. A transmitter and a receiver. Transmitters are any wall-mounted or hand-held controller. The transmitter has a CR2430 battery that lasts a long time, 2-5 years. The transmitter only sends an RF (Radio Frequency) command to the receiver. All the "intelligence" is in the receiver. The receivers are the VaLO family of transformers and dimmers.

Yes. We have been supplying wireless devices for a long time and rarely have any problems with them.

Yes, they are.

-Tailor: EXXACT

-BERKER: S1,B1,B3,B7 Glass

-GIRA: Standard55, E2, Event, Esprit

-JUNG: A500, Aplus

-MERTEN: M-smart, M-arc, M-plan

Press the "Learning" button on the receiver once and within 3 seconds press the button of your choice. The light will flash after successful pairing.

Hold down the "Learning" button on the receiver for 5 seconds. The light will flash once to indicate success.

4 pieces. Note! Android/Ios app is a "button".

4 pieces, so for example in the kitchen the transformers are on opposite walls and they light 99,9% of the time at the same time, but if the 0,1% bothers you, there is a button for each =).

We have +20pcs in the store and the limit is 30pcs in the same location after which the signal sites run out.

30m in free airspace. Gypsum wall reduced to 10m. The only problem is the reinforced concrete (It's good music though!)... It won't let the signal through because it creates a Faraday cage.

The fault may be in the receiver or the button.

- switch off the power (the receiver may have jammed due to a radio interference)

- replace the battery in the button =)

- reset the button and teach again (points 5. and 6.)

- If the button only works in the immediate vicinity of the receiver, the problem is radio interference from elsewhere. Usually it is a transformer.

- If you have a transformer and a separate receiver, try to see if the lights work with just the transformer without the receiver in between. If not, the transformer is broken.

- If nothing helped, LedStore's VaLO product line has a 5 year warranty, so don't worry!

Unfortunately not. That's not an open prototype. We have Zigbee versions for that. Zigbee works with all Zigbee devices.

May be in the same place, we have not observed any effect on each other over the years. Generally the best place is in the same room as the transmitter, i.e. not behind 3 walls in the technical room... Of course if there are plaster walls in there too then it will probably still work..

Unable to. Channels are intended for multicolour different shades. Each channel has only negative voltage. The transformer has only one positive output.

A standard sheet metal or plaster hatch is a viable solution.

Read more