2pcs Recessed LED PANEL 300x300 — UPPOAVA, colour changeable 2800K-5800K (CCT) with control unit

2pcs UPPOAVA panel 300 CCT, 18W led is a multi-purpose light for indoor and outdoor use. Suitable for bathrooms, terraces and kitchens. The light is dimmable, the light colour is adjustable and it is moisture-proof. The light comes with a 5-year guarantee. This is a complete package with temperature adjustable controls. Can be recessed or surface mounted on a panel (OPTIO)

Led technology

It does not matter exactly what kind of light the light produces. We recommend choosing a light with a colour rendering of over 90 CRI to make the lighting look natural to the eye. UPPOAVA -led panels have a CRI of 98.

The colour of the light is adjustable The driver/control unit and wireless controller are included in the order, as well as the wiring harness. There are 3m cables from the driver to the lights. The light colour can be adjusted between 2800K (warm white) and 5800K (cold white). There is also an optional surface-mounting frame if the lights are to be surface-mounted. Note at that point that the driver is only inside one of the frames and the BLACK cable runs between. A hole must also be drilled in the surface frame to route the cable to the second light.

The UPPOAVA -led panel uses an edge cover, so the light comes in softly with no pinpointing and the matte acrylic still diffuses the light to a pleasantly even light. The UPPOAVA panel 300, 18W led is equivalent in light output to 125W halogen, which is 1500 lumens.

See here for installation examples and ideas

Installation

The light is recessed in the ceiling or surface-mounted. When recessed, the mounting hole should be 283x283mm. The light is 295x295x22mm and the power supply fits inside the surface mount frame. The power supply can accommodate a maximum of two 300*300 panels. The driver is supplied with 230V and a splitter is supplied at the rear of the driver, to which the 3m connection cables for the panels can be connected. The 3m cables can also be connected in series to form a 6m intermediate cable, if the driver is next to one of the panels.

The light will fit into a typical ceiling structure with only 48x48mm of 48x48mm insulation and 13mm plasterboard under the vapour barrier. If the vapour barrier is installed loosely, we recommend installing a board or plasterboard above the light to prevent the insulation from sagging. The LED will not reach high temperatures, so no fire protection is required. However, it is not recommended to mount the Led light on any material and an air space of e.g. 1-2 cm can be left.

The light is available with an OPTIONA surface mounting frame which is 50mm high. The driver fits inside the frame.

Dimming and colour adjustment

Using the VaLO series CCT receiver and pushbutton, the colour temperature of the light light can be adjusted between 2500K and 6500K. In addition, the light can be dimmed with the same button.

• From the top left corner (on/off symbol) the lamp goes off and on
• From the bottom left (sun), the lamp dims. Dimming is done by pressing and holding the button. Pressing the button again (for a long time) will divert the lighting level in a different direction than the previous press.
• From the top right corner (WW) you can adjust the colour temperature of the lamp to a warmer temperature.
• From the bottom right (CW) you can adjust the colour temperature of the lamp to a cooler temperature.

Why choose a UPPOAVA -led panel?

• Dimmable
• Light colour is adjustable
• Moisture-proof (IP54)
• Excellent colour rendering (CRI 98)
• Good light output
• Superior 5 year warranty for LED light + 5 years for power supply
• UPPOAVA light lifetime up to 50000
• Saves energy and therefore money
• You can use the same light both indoors and outdoors
• Finished, timeless design
• Easy to install